Recent Articles
BAND SELECTION
Set AP to Operate in U-NII-3: Aura strongly recommends operating only in U-NII –3. FCC Part 15 permits Tx power of up to 1 watt (or 1000mw) for point to multi – point networks in U-NII 3 and U-NII 3 is not subject to radar sweeps. By comparison ...
Apogee Manager Will Not Authenticate Apogee Antenna
Apogee Manager Will Not Authenticate Apogee Antenna If a tunnel between Apogee Manager and an Apogee antenna has been successfully been established but Apogee Manager will not authenticate the Apogee. Log into Apogee Manager and record the MAC ...
Troubleshooting Checklist
TROUBLESHOOTING CHECKLIST Apogee Not Powering Up Ensure that other devices can be successfully powered by the same power source as Apogee. Refer to Section 3.2 of the Installation Guide and confirm connections between the power source (Switch, UPS) ...
CONFIGURING THE ACCESS POINT TO WORK WITH APOGEE
CONFIGURING THE ACCESS POINT TO WORK WITH APOGEE When installing outdoor, select an AP designed for outdoor use For optimal performance, select an AP that is capable of 1 watt of transmit power. Disable internal antennas, if any. Use only Aura – ...
Apogee Installation: Securing the Apogee and Connecting to Apogee Manager
Log into Apogee Manager Slide the Apogee down over the 22” X 2” diameter antenna stub which is part of whatever mount type the network operator has selected (e.g. mast, NPRM, sidewall, side post). At this time DO NOT attach the LMR240 RF cables. To ...